Cisco Cisco Catalyst Blade Switch 3040 for FSC インストールガイド

This section applies to products to be installed in the European Union. 

The equipment is intended to operate under the following environmental conditions with respect 
to EMC:

A separate defined location under user’s control. 

Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.

AC power distribution shall be one of the following types, where applicable: TN-S and TN-C as 
defined in IEC 364-3.

In addition, if equipment is operated in a domestic environment, interference may occur.

This section includes the EMC Class A warnings for the Cisco Catalyst Blade Switch 3020 for HP:

Modifying the equipment without Cisco’s authorization may result in the equipment no longer 
complying with FCC requirements for Class A digital devices. In that event, your right to use the 
equipment may be limited by FCC regulations, and you may be required to correct any interference to 
radio or television communications at your own expense.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant 
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference when the equipment is operated in a commercial environment. This equipment generates, 
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the 
instruction manual, may cause harmful interference to radio communications. Operation of this 
equipment in a residential area is likely to cause harmful interference in which case users will be 
required to correct the interference at their own expense.

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.