Cisco Cisco Broadband Access Center Telco Wireless 3.8

 lists the open bugs in the Cisco BAC 3.8 release.

Click on the identifier to view the impact and workaround for the bugs. This information is displayed in 
the Bug Toolkit. You can track the status of the open bugs, using the 

 

TR196 femto changes for 2G and 3G neighbor count handling

The queued or expedited alarms should be converted to SNMP traps

Generate Clear alarm when current alarms is cleared.

GA Tampering Flow changes

BAC 3.5.3 CPEaaS extension porting into BAC 3.8

GA changes for 2G and 3G neighbor count handling

GA Flow: Session not completed after device is Tampared

GA:Irrespective of method, all the REM data should be in location event

Provisioning Status should not be set if enabling service  is not done

Device details page could not be viewed

If there are no instances of {i} on the device then flow gets blocked

Whitelist value in ACCESS-ACCEPT pads 00 for IMSI  if length is < 8

There should be an option to have the conditionals around the instances

DPE allows to provision an interface even when the status is UP & NOT RUNNING

DPE incorrectly terminates file download session while transfer is in progress

DPE intermittent outage

BAC disables the radio when a wrong value is set for any parameter

FC-LAST-LC-NWL flag shows 'matched' even though NWL mismatch occurred

IPv6 lease query request in failover scenario, when primary is shutdown

Firmware file could be deleted even if a reference exists

Wrong error message returned from proxy operation with wrong data type

Deleted helper scripts are not removed from script scope

NTPD should be listed as a requirement for installing BAC on Linux

DPE CLI password reset option is unavailable

RDU reboots during config template generation

LQ destination address issue in DPE