Cisco Cisco NetFlow Generation Appliance (NGA) 3340 インストールガイド
5
Quick Start Guide for Cisco NetFlow Generation Appliance
Quick Start Guide for Cisco NetFlow Generation Appliance (NGA) 3340
Quick Start
Figure 1
NGA3340-K9 Rear Panel
Step 5
Connect up to four 10 Gb Ethernet Cisco NGA data ports to your traffic sources (for example, a Nexus
7000 Series switch SPAN port). See location numbers 1 to 4 in
7000 Series switch SPAN port). See location numbers 1 to 4 in
Then configure your traffic source, by doing one of the following:
•
Create one or more Switched Port Analyzer (SPAN) sessions (also known as port mirroring) from
the Nexus device to Cisco NGA using the Nexus supervisor command line interface.
the Nexus device to Cisco NGA using the Nexus supervisor command line interface.
Then verify replication via the SPAN destination of the Cisco Nexus switch, by entering on the
switch console:
switch console:
show interface ethernet <module>/<port>
•
Connect a network tap.
See your router or switch device documentation for details on how to set up this monitoring
configuration. For details on how to optionally configure the IP address of your switch as a managed
device, see the
configuration. For details on how to optionally configure the IP address of your switch as a managed
device, see the
.
Step 6
To access the console remotely, connect the COM1 serial port to a terminal server. See location number 5
in
in
Table 2
Rear Panel Location Numbers
Location
Number
Number
Description
Location
Number
Number
Description
1
PCIe riser 1/slot 1
7
Serial port (RJ-45 connector)
2
PCIe riser 2/slot 2
8
Dual 1-Gb Ethernet ports (LAN1 and
LAN2)
LAN2)
3
Modular LAN-on-motherboard
(mLOM) card slot
(mLOM) card slot
9
VGA video port (DB-15)
4
Grounding-lug hole (for DC
power supplies)
power supplies)
10
Rear unit identification button/LED
5
USB 3.0 ports (two)
11
Power supplies (up to two, redundant as
1+1)
1+1)
6
1-Gb Ethernet dedicated
management port
management port