Cisco Cisco D9858 Advanced Receiver Transcoder インストールガイド

 

166 

OL-31087-01 

 

 

The disaster recovery settings allow you to configure the search path when a disaster 
occurs. By default, the disaster recovery feature is enabled. For more information on 
disaster recovery, see Disaster Recovery (on page 7). 
1  From the user interface of the D9858, choose Input > Disaster Recovery. The 

Disaster Recovery Setup page is displayed. 

2  From the Enable Disaster Recovery drop-down list, choose to enable or 

temporarily disable the disaster recovery feature. Choose Yes (default) to enable 
disaster recovery. Choose No to set the disaster recovery into maintenance mode. 
It will automatically set the Disaster Recovery back to Yes after five minutes. 
This prevents the user from accidentally disabling disaster recovery 
permanently. To disable disaster recovery, remove all the disaster recovery 
configurations (Search Path settings below). 
The maintenance mode allows you to perform any maintenance operations (such 
as IP setup), without the unit declaring disaster and initiate a disaster recovery 
search path. 
Note: Although the default is set to Yes, the disaster recovery is not operational 
until the Search Path is configured.