Cisco Cisco D9804 Multiple Transport Receiver インストールガイド
Viewing System Information
78-4042990-01 Rev B
131
Setting up SNMP Trap Destinations
To Add a Trap Destination
Proceed as follows to add a Trap Destination:
1 From the user interface of the D9804 MTR, click the System tab, and then the
1 From the user interface of the D9804 MTR, click the System tab, and then the
Trap Destinations icon from the sub-page.
2 Click Add Trap Destination.
3 Type the IP Address that sets the destination for SNMP trap messages for events
3 Type the IP Address that sets the destination for SNMP trap messages for events
(e.g., fault messages). You can enter up to 12 characters (e.g., 155.128.100.200).
4 Type the Community String for the trap destination (IP Address entered above).
Enter public or custom string. The default is public. You can enter a string up to
35 characters.
35 characters.
5 Click Apply. The new trap destination is created and listed in the table below.
To edit an existing Trap Destination
Proceed as follows to edit an existing Trap Destination:
1 From the user interface of the D9804 MTR, click the System tab, and then the
1 From the user interface of the D9804 MTR, click the System tab, and then the
Trap Destinations icon from the sub-page.
2 From the Select Trap Destination to update drop-down, select the trap
destination entry you want to edit.
3 Edit the IP Address and/or Community String for the SNMP trap messages.
4 Click Apply. The entry is updated.
4 Click Apply. The entry is updated.