Cisco Cisco D9804 Multiple Transport Receiver インストールガイド
Viewing System Information
78-4042990-01 Rev B
133
Configuring Warning Settings
Proceed as follows to configure the Warning Settings:
1 From the user interface of the D9804 MTR, click the System tab, and then the
1 From the user interface of the D9804 MTR, click the System tab, and then the
Warnings Setup icon from the sub-page.
2 Set the Reset Delay, in seconds. It is the time delay for warnings to be cleared
after the condition has been cleared. The range is from 1 to 60 seconds. The
default is 5 seconds.
default is 5 seconds.
3 Click Save.
4 The warnings table displays a list of the warning messages. For each of the
4 The warnings table displays a list of the warning messages. For each of the
warning message, you can set the Enable and Trap information.
Select Yes for Enable to report the warning message. Select No, the fault won’t
be reported.
Note: Enable must be set to Yes for Relay and Trap messages reporting to be
functional.
Select Yes for Enable to report the warning message. Select No, the fault won’t
be reported.
Note: Enable must be set to Yes for Relay and Trap messages reporting to be
functional.
5 Set the Trap to Yes and the SNMP trap message will be sent to the trap
destination. Select No and the warning message will be ignored.
6 Click Save.