Cisco Headend System Release 2.7 インストールガイド
Chapter 1 Before You Activate SBE
6
740223 Rev F
11 Does a check mark appear in the DIS Enable field?
If yes, then the billing system is setting the DIS enable flag.
If no, you must contact your billing provider to have them enable the DIS flag
on billing transactions being sent to the DNCS.
12 Repeat steps 9 and 10 on the other two DHCTs in your test group to verify that
the DIS Enable flag is being set.
13 Click Cancel to close the Set Up DHCT window and return to the DHCT
Provisioning window.
14 Click Cancel to close the DHCT Provisioning window and return to the DNCS
Administrative Console.
15 Go to
Test Two - Check Recently-Staged DHCTs (on page 6).
Test Two - Check Recently-Staged DHCTs
After you verify that your billing provider is enabling the DIS flag on billing
transactions to the DNCS, you need to run another test on a few recently staged
DHCTs to ensure that the DIS Enable flag is being received.
Important: Setting the DIS flag to enabled when loading SSC CableCARD set-top
Important: Setting the DIS flag to enabled when loading SSC CableCARD set-top
boxes will cause binding and staging problems. Instead, stage them without special
flags enabled, enable DIS after staging is complete, and send a Hit in order to obtain
Type 8 EMMs.
WARNING:
Do not enable DIS in billing on SSC CableCARD set-top boxes.
Do not use CableCARD set-top boxes for DIS flag testing purposes.
Complete the following steps on a few recently-staged DHCTs to perform the
second test, which ensures the DIS flag is enabled.
1 On the DNCS Administrative Console, click the DNCS tab.
2 Click the click Element Provisioning tab.
3 Click DHCT. The DHCT Provisioning window appears.
4 In the Select Option area, click the Open option, if it is not already selected.
5 Do you know the MAC address for the DHCT you want to check?
1 On the DNCS Administrative Console, click the DNCS tab.
2 Click the click Element Provisioning tab.
3 Click DHCT. The DHCT Provisioning window appears.
4 In the Select Option area, click the Open option, if it is not already selected.
5 Do you know the MAC address for the DHCT you want to check?
If yes, click the By MAC Address option, then click in the corresponding
field, and type the MAC address for the DHCT you want to check.
If no, click the By Serial Number option, then click in the corresponding
field, and type the serial number for the DHCT you want to check.
6 Click Continue. The Set Up DHCT window opens for the DHCT you want to
check.