Cisco Headend System Release 2.7 インストールガイド
Complete System Validation Tests
4023373 Rev B
39
Complete System Validation Tests
Introduction
After you restart the cron jobs and the billing and other third-party applications, you
must perform system validation tests.
must perform system validation tests.
Prerequisites
The test DHCT(s) you use for this procedure must meet the following conditions:
Must be authorized for all third-party applications
Must not be authorized to view a PPV event without specifically buying the
PPV event
PPV event
Must have a working return path and be capable of booting into two-way mode
Verifying a Successful Installation
Complete the following steps to verify that the SARA Server software installed
successfully.
successfully.
Important: If this procedure fails, do not continue with the remaining procedures in
this publication. Instead, contact Cisco Services.
1 Perform a slow-and-fast boot on a test DHCT as follows:
this publication. Instead, contact Cisco Services.
1 Perform a slow-and-fast boot on a test DHCT as follows:
a Boot a DHCT.
Note: Do not press the power button.
b Access the Power On Self Test and Boot Status Diagnostic Screen on the
DHCT and verify that all parameters, except UNcfg, display Ready.
Note: UNcfg displays Broadcast.
c Wait 5 minutes.
d Press the power button on the DHCT to power on the DHCT.
e Access the Power On Self Test and Boot Status Diagnostic Screen on the
d Press the power button on the DHCT to power on the DHCT.
e Access the Power On Self Test and Boot Status Diagnostic Screen on the
DHCT.
f Do all of the parameters, including UNcfg, display Ready?
–
If yes, go to step 2.
–
If no, contact Cisco Services.
2 Ping the DHCT.