Cisco Headend Digital Broadband Delivery System インストールガイド
Restart Utilities
4038415 Rev A
75
Restart Utilities
Restart the dhctStatus Utility
The dhctStatus Utility usually runs from cron and will start at its scheduled time.
Restarting the signonCount Utility
If the signonCount utility was running prior to the upgrade, follow these steps to
restart the utility. If you do not want to start the signonCount utility at this time,
skip this procedure and go to the next procedure in this chapter.
1 Type the following command and press Enter. The signonCount process starts
restart the utility. If you do not want to start the signonCount utility at this time,
skip this procedure and go to the next procedure in this chapter.
1 Type the following command and press Enter. The signonCount process starts
and begins displaying the set-top sign-on status.
signonCount
2 Press the Ctrl and C keys simultaneously to stop the terminal output.
3 Type the following command and press Enter to monitor the signonCount utility
3 Type the following command and press Enter to monitor the signonCount utility
status. The terminal displays the last 10 lines in the output file, as well as any
new entries made to the output file.
new entries made to the output file.
tail -f /dvs/dncs/tmp/signonCount.out
4 Press the Ctrl and C keys simultaneously to terminate the tail process.
Restart the cmd2000 Utility
1 To restart the cmd2000 utility, type the following commands and press Enter
after each command.
svcadm –v enable –rs svc:/application/cmd2000:default
svcadm –v enable –rs
svc:/application/cmd2000_listener:default
svc:/application/cmd2000_listener:default
2 Type the following command and press Enter to verify that the cmd2000 services
have been enabled. The system displays both cmd2000 services as online.
svcs | grep cmd2000
Note: If the cmd2000 services show a status of Maintenance, or if they are not
online, call Cisco Services for assistance.
online, call Cisco Services for assistance.