Cisco Cisco StadiumVision Mobile インストールガイド
© 2011 Cisco Systems, Inc. All rights reserved
Page 21 of 71
6. Loosen the captive fastener. (See label 1 in Figure 17.)
7. Lift the air duct straight up and remove it from the chassis. (See label 5 in
The chassis with the air duct removed resembles Figure 18.
Figure 18. Cisco ADE 2140 with Air Duct Removed
Replacing the Air Duct
To replace the air duct:
1. Slide the duct forward until it is flush with the front of the chassis and stops.
2. The front edge will engage at the front panel. (See label 3 in Figure 17.) The
metal tab at the rear will engage. (See label 4 in Figure 17.)
3. Push the air duct down into the chassis.
4. Tighten the captive fastener. (See label 1 in Figure 17.)
5. Replace the chassis cover.
Installing Additional RAM
The Cisco ADE 2140 Series appliance comes with 2 GB of RAM. The
recommended configuration for the SV Director Server is 4 GB. Therefore, you
need to install an additional DIMM.
recommended configuration for the SV Director Server is 4 GB. Therefore, you
need to install an additional DIMM.
Warning! This process assumes a new installation. Before installing any
components, ensure that the device is powered down. Also, attach the antistatic
wrist strap to your wrist and connect its cord to the ESD socket on the top, left-
hand side on the front of the chassis.
components, ensure that the device is powered down. Also, attach the antistatic
wrist strap to your wrist and connect its cord to the ESD socket on the top, left-
hand side on the front of the chassis.
The memory is not hot-swappable. Before removing or replacing any dual in-line
memory module (DIMM), you must first take the unit out of service by turning off
the power button and unplugging the AC power cord from the unit or wall outlet.
memory module (DIMM), you must first take the unit out of service by turning off
the power button and unplugging the AC power cord from the unit or wall outlet.