Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
Installing Accessories
station. Do not change this pad in the field unless required by system design.
3
Install other options or accessories as desired, or proceed to Installing the Amplifier
Module (on page 32).
To Install Equalizers
Complete the following steps to install the equalizers in the amplifier.
Note: For best results, follow this installation procedure exactly.
1
Begin this procedure with the housing open. Refer to To Open the Node Housing (on
page 15).
Note: These accessories can be installed without removing the amplifier cover.
Note: These accessories can be installed without removing the amplifier cover.
2
Install the forward input equalizer specified by the design print in the forward input
equalizer slot. Or, install the correct inverse equalizer specified by the design print
for your system in the forward input equalizer slot. For a list of available accessory
pad values and part numbers, see Technical Information (on page 95).
Note:
Be sure that all the pins on the forward input equalizer or inverse equalizer
bottom align with the pin holes in the equalizer slot, allowing the equalizer to
install flat against the amplifier module.
The same inverse equalizer is used for either 870 MHz or 1 GHz.
The locations for equalizers are approximately the same for all GainMaker Line
Extender amplifiers. The illustration above shows a typical example.
OL-31155-01
29