Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
Chapter 2 Installation and Configuration
The forward interstage equalizer is installed at the factory, and should not be
changed in the field. While it is a 1 GHz equalizer, it is appropriate for use in
both 1 GHz and 870 MHz system applications.
The plug-in interstage equalizer and an on-board interstage equalizer combine to
produce the total internal tilt for the station. The plug-in interstage equalizer
value is different from one type of amplifier to another by design, in order to
achieve optimum performance.
3
Install the reverse equalizer specified by the design print in the reverse equalizer slot.
For the exact location of the reverse equalizer, refer to the accompanying illustration.
For a list of available reverse equalizers, see Technical Information (on page 95).
4
Install other options or accessories as desired, or proceed to Installing the Amplifier
Module (on page 32).
To Install the Surge Protector
Complete the following steps to install the crowbar surge protector in the amplifier.
1
Begin this procedure with the housing open. Refer to To Open the Node Housing (on
page 15).
2
Remove the amplifier cover by loosening the amplifier cover screws.
3
Install the crowbar surge protector in the surge protector slot. Refer to the illustration
below.
30
OL-31155-01