Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
Chapter 2 Installation and Configuration
30
3 Lift and turn over the amplifier module.
4 Remove the existing LPTF from the reverse amplifier board.
5 Install the new LPFT in the reverse amplifier board. Be careful, the LPFT pins
4 Remove the existing LPTF from the reverse amplifier board.
5 Install the new LPFT in the reverse amplifier board. Be careful, the LPFT pins
should be inserted into the corresponding holes in the reverse amplifier board, as
marked with red circle in the illustration below.
marked with red circle in the illustration below.
6 Install other options or accessories as desired, or proceed to Installing the
Amplifier Module (on page 33).
To Install the Plug-in Signal Director (High Gain Dual Only)
Complete the following steps to install the signal director in the amplifier.
1 Begin this procedure with the housing open. Refer to To Open the Amplifier
1 Begin this procedure with the housing open. Refer to To Open the Amplifier
Housing (on page 13).
Note: This accessory can be installed without removing the amplifier cover.
2 Choose the correct signal director for your system as specified by the design print.