Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
Chapter 3 Balancing and Setup
60
5 Adjust the AGC gain control potentiometer to match the level you measured in
step 3.
6 Move switch S1 back and forth between position 1 and position 3.
Important: Let the amplifier module settle before reading signal levels.
The signal level should not vary when you switch between positions 1 and 3. If the
signal level does vary, repeat steps 4 through 6 as needed until the signal level
does not vary between switch positions 1 and 3.
The signal level should not vary when you switch between positions 1 and 3. If the
signal level does vary, repeat steps 4 through 6 as needed until the signal level
does not vary between switch positions 1 and 3.
7 Set switch S1 to position 3 for AGC operation mode.
8 Proceed to Balancing the Reverse Path (on page 68).
8 Proceed to Balancing the Reverse Path (on page 68).