Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
Chapter 2 Installation and Configuration
24
Attaching the Coaxial Connectors
To Trim the Center Conductor
The 1.2 GHz GainMaker Line Extender requires pin-type connectors for all RF
connections.
connections.
Before you begin, confirm the following:
The coaxial cables are cut to the proper length and core-stripped to connector
manufacturer specifications.
manufacturer specifications.
The coaxial cable connector center pins are trimmed to 1.25 inches (31.75 mm)
from the shoulder of the connector.
from the shoulder of the connector.
To Connect the Coaxial Cable Pin Connector to the Line Extender
Housing
Housing
Complete the following steps to connect the coaxial cable pin connector to the 1.2
GHz GainMaker Line Extender housing:
1 Begin this procedure with the line extender housing open. Refer to To Open the
GHz GainMaker Line Extender housing:
1 Begin this procedure with the line extender housing open. Refer to To Open the
Line Extender Housing (on page 15).
2 If the coaxial cable connector center pin extends more than the length specified in
To Trim the Center Conductor (on page 24), trim the pin with heavy-duty wire
cutters.
cutters.
3 Insert the appropriate coaxial connector into the housing at the desired housing
port. Tighten the connector nut according to manufacturer specifications.
4 Tighten the seizure screw from 2 ft-lb to 5 ft-lb (2.7 Nm to 6.8 Nm).
5 Repeat steps 2 through 4 for the other RF port.
6 Proceed to Installing the Housing (on page 25).
5 Repeat steps 2 through 4 for the other RF port.
6 Proceed to Installing the Housing (on page 25).