Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
748052 Rev C
GainMaker Amplifier Reverse Switch Removal Instruction Sheet
5
System Amplifier Reverse Switch Removal,
Continued
Follow these steps to disconnect the power from a system amplifier located in the
field.
1.
Using a torque wrench, loosen the six housing bolts in the housing lid, and
open the housing.
2.
Pull straight up on each of the AC shunt power directors to remove them.
Important: Be sure to remove all four of the AC shunt power directors.
Refer to the following illustration for the locations of the AC shunt power
Important: Be sure to remove all four of the AC shunt power directors.
Refer to the following illustration for the locations of the AC shunt power
directors.
Result: Power is disconnected from the system amplifier.
3.
Proceed to Removing the Amplifier Module From the Housing.