Cisco Cisco Content Security Management Appliance M1070 ユーザーガイド

The following figure shows the Packet Capture process running.

To stop a running capture, click Stop Capture. A running capture that has previously been started is 
preserved between sessions.

The GUI only displays packet captures started in the GUI, not from the command line prompt using the 
packetcapture > start command. Similarly, the command line only displays the status of a current 
packet capture run started from the command line prompt using the packetcapture > start command. 
Only one capture may be running at a time.

There are two ways to edit packet capture settings:

To edit the packet capture settings in the CLI, run the packetcapture > setup command from the 
command line prompt.

On the Security Management appliance, choose Help and Support > Packet Capture.

Select Edit Settings.