Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch テクニカルリファレンス

Class of Service Commands

Cisco Small Business 200E Series Advanced Smart Switch Command Reference

376

This section describes the commands you use to configure and view Class of 
Service (CoS) settings for the switch. The commands in this section allow you to 
control the priority and transmission rate of traffic. 

This command maps an 802.1p priority to an internal traffic class for an interface 
(in Interface Config mode) or for all interfaces (in Global Config Mode). Use the 

no 

form of this command to reset an 802.1p priority to its default internal traffic class 
value for an interface or all interfaces.

classofservice dot1p-mapping dot1ppriority trafficclass

Global Config

Interface Config

The 802.1p priority value. The range is 0–7. 

The trafficclass value. The range is 1–8.

Displays the global Dot1p (IEEE 802.1p) priority mapping to 
internal traffic classes or the mappings for a specific 
interface.