Samsung SCC-B5393P ユーザーズマニュアル

Before installation, you have to be familiar with the above cautions and fill in the holes that are 

not used for installation.

1.  Attach the provided template to the place 

to be installed and penetrate a hole (5mm 

diameter, minimum depth 35mm) for fixing 

your camera to insert the provided plastic 

anchor (HUD 5) to the full. 

2.  After connecting both power and video 

cables, put them in order not to have 

damage during installation. 

3.  Remove the Dome cover. For more 

information, see step 2 in “To install your 

camera bottom on a pipe” on page 13.

4.  Install your camera. After aligning the hole 

where the plastic anchor is inserted with 

the camera installation hole, make tight 

four ASSY screw-tappings where O-rings 

are inserted. (If no O-rings are inserted, 

water leak may happen.)

5.  Adjust the camera lens direction. For 

more information, see page 17, “Adjusting 

the camera direction.”

6.  Attach the Dome cover. For more 

information, see step 3 in “To install your 

camera bottom on a pipe” on page 13.

1

  Penetrate a wiring hole toward the 

pipe. (Recommended hole size: within 

30mm diameter)

2

  Attach the gasket on the bottom of the 

product as shown below. You have to 

correctly align the hole with the pipe 

hole.


  If the hole deviates from the gasket, 

water leak may happen.

Gasket

AB68-00649D(02)Eng.indd   15

2007-05-14   ｿﾀﾈﾄ 7:42:13