Samsung SNT-1010P ユーザーズマニュアル

Chapter 2 Installing and Connecting

Installing SNT-1010/Connecting SNT-1010

If you connect the SNT-1010 to the Internet and
setup the network settings,you can monitor the
picture of the connected camera in real-time.

To install onto a dedicated shelf

When you install this product on a wall, check if the wall is strong enough to sustain the weight of the product.
Dropping of this product may cause an injury when it is installed on a wall. Therefore fix the product firmly when
you install this product on a wall.
This product is designed for indoor use. Install this product in a dry place so that it is not wet by rain or snow.

Notice

Insert the Fixing Block onto a side of the product and turn it in the arrow direction
as described in the figure.

Fix the Fixing Metal onto the Fixing Block using the 2 screws (small).

Fix the Fixing Metal so that the bottom of the Fixing Metal faces forward.

Fix the Fixing Metal on the shelf using one screw (big).

Assemble as follows for both sides of the main body.

Installing and Connecting

Installing SNT-1010

(Continued)

Connecting SNT-1010

Installing and Connecting

To connect to RS-485

Ensure that the RS-485 device you want to use is compatible with SNT-1010.
Ensure that you connect to the RS-485 device so it fits the polarity of the port.

Notice

You can use the rear port of SNT-1010 to connect to the RS-485 device.

You can install and control over a PTZ camera that supports RS-485 communications.

You can make the connection in either Half Duplex or Full Duplex.

The baud rate available is : 600/1200/2400/4800/9600/19200/38400.