Samsung SNT-1010P ユーザーズマニュアル
17
Chapter 2 Installing and Connecting
Connecting the SNT-1010
16
Connecting SNT-1010
(Continued)
Installing and Connecting
LINE-OUT
SPEAKER
Pre-Amp
Network
Pre-Amp
Computer
Pre-Amp
To connect to Audio Input/Output
Audio I/O Block Diagram
1
Connect the [AUDIO IN ] port of the SNT-1010 with the LINE OUT portof the amplifier that the
microphone is connected to.
microphone is connected to.
Audio Codec :G.711 PCM, µ-law 64kbps 8kHz sampling
Full duplex Audio
Audio in : Used for mono signal line input (Max.2.4 Vpp)
Audio out : Used for mono signal line output (Max.2.4 Vpp)
Line out impedance :600ohm
2
Connect the [AUDIO OUT ] port of the SNT-1010 with the LINE IN port of the speaker.
SPEAKER
Microphone
Microphone
PC
If you connect the microphone to the AUDIO OUT port, you can't hear a sound.
MIC IN is not enabled.
MIC IN is not enabled.
Notice