Zebra 01407-000 ユーザーズマニュアル
17
Installation
Making a Test Printout
03/03/2009
TTP 1020™/TTP 1030™ Technical Manual
P1003643-001
Making a Test Printout
You can make a self-test printout if you want to verify that the printer operates correctly. See
.
Installing a Printer Driver
Printer drivers are available on the Zebra web site
http://www.zebra.com
. Please follow the
installation instructions that accompany the drivers.
Installing a Paper-near-end Sensor (Option)
A paper-near-end sensor alerts the system when a certain length of paper remains on the roll.
The purpose of this sensor is to get an early alert so that you can replace the paper roll in time
in remotely located kiosks.
The purpose of this sensor is to get an early alert so that you can replace the paper roll in time
in remotely located kiosks.
Paper roll holders supplied by Zebra are equipped with paper-near-end sensors. Just connect
the cable to connector J10 at the back of the printer; see
the cable to connector J10 at the back of the printer; see
.
Figure 6 • Paper-near end sensor connection
+5
+5
Paper-near-
end sensor
end sensor
2
3
1
J10
PL SENSE
SW97081A
180 ohm
0.1 uF
Paper roll
Sharp
GP2S40
GP2S40
New
Near
end
end
Roll holder shaft