Zebra 01407-000 ユーザーズマニュアル
03/03/2009
TTP 1020™/TTP 1030™ Technical Manual
P1003643-001
6
Aligning Preprint and
Thermal Print
The printer can synchronize the cutting of the receipt with black-marks printed on the back of
the paper. You use this function when you have preprint on the receipt and you don't want a cut
in the middle of that preprint, or text printed on top of the preprint.
the paper. You use this function when you have preprint on the receipt and you don't want a cut
in the middle of that preprint, or text printed on top of the preprint.
The sensor used to detect the black-marks is the same sensor as used for paper end detection. It
is positioned 9 mm from the left edge of the paper entry, and 25 mm behind the cutter (as seen
from the presenter [output] side of the printer). The sensor accuracy is about ±0.5 mm so avoid
designing receipts with too high demands for synchronization.
is positioned 9 mm from the left edge of the paper entry, and 25 mm behind the cutter (as seen
from the presenter [output] side of the printer). The sensor accuracy is about ±0.5 mm so avoid
designing receipts with too high demands for synchronization.
Figure 16 • Recommended Black Mark Size and Position
The sensor triggers on the black-to-white transition of the black-mark, which is when the black
print ends (trailing edge).
print ends (trailing edge).
Cut line
Paper viewed from
inner side (opposite
to thermal-coating side)
inner side (opposite
to thermal-coating side)
SW95001B
Cut line
Paper
feed
direction
25 mm
Black mark size 5 x 9 mm
75 mm
25 mm
9.1 mm
Punched hole 5 mm
Preprinting not
recommended
within this zone
recommended
within this zone