Zebra 01407-000 ユーザーズマニュアル

Disassembly

03/03/2009

TTP 1020™/TTP 1030™ Technical Manual

P1003643-001

Remove the plastic cover.

Lift the collar on the print head connector to relieve the contact pressure, and disconnect 
the print head cable.

Disconnect the printer-module cable from J2 on the control board.

Remove the screw limiting the printer mechanism tilt angle.

Fold the printer mechanism backwards

Remove the four rear screws on the underside of the printer.

Remove the two screws holding the printer to the plate behind the control board.

If the printer module is to be replaced by a new one, remove the paper release lever (two 
screws)

If applicable, fit the print head release lever on the new printer mechanism.

Install the print module in the reverse order.

Remove the plastic cover.

Disconnect all cables from the control board. Remember to lift the print head connector 
collar to relieve the contact pressure before pulling out the print head cable.

Remove the four spacers holding the board, and remove it.

Install the control board in the reverse order. 

When the printer is assembled, load new firmware to the printer. See page .