Zebra 01407-000 ユーザーズマニュアル

Maintenance
Disassembly

P1003643-001

TTP 1020™/TTP 1030™ Technical Manual

03/03/2009

Remove the plastic cover.

Remove the screw limiting the tilt angle of the printer mechanism.

Disconnect the cutter cable from J9, and the presenter cable from J1.

Remove the two o-rings holding the cables to the printer chassis. 

Remove the two screws holding the cutter to the bottom of the printer chassis.

Slide the cutter backwards, lifting it slightly so it gets free from the cable-tie wings of the 
printer chassis.

Put the cables from the presenter and cutter motor through the hole in the lower end of the 
cutter assembly.

Push up the moving blade to its top position.

Slide the cutter in place under the cutter motor bracket.

Use a screwdriver and turn the cutter-motor until the knife actuator enters the hole in the 
moving blade.

Fasten the cutter assembly with four screws.

Fit the screw limiting the printer mechanism tilt angle.

Fit the plastic cover.

Remove the cutter.

Remove the screw holding the assembly to the presenter.

Slide the cutter motor assembly backwards, lifting it slightly so it gets free from the cable 
tie wings of the printer chassis.

Gently pull the presenter cable through the hole in the cutter assembly bracket.

Install the cutter motor/sensor assembly in the reverse order. 

Apply grease on the knife actuator and the hole where it enters the moving blade. 

Make sure the knife actuator enters the hole in the moving blade when refitting the cutter.