Samsung SSA-S3020 ユーザーズマニュアル

 

I/O time setup

I/O time setup

READER #1 ERROR OUTPUT SETUP

READER #1 ID Error Output Setup

Press the 

 SETUP MENU button.

Use the buttons 

 and 

 to move to the RD1 ID ERROR item and 

press 

.

You can make input when the prompt blinks.

If you enter ‘00’, no output setting is configured.

Use the keypad to enter the time for each output operation and press 

.

DR : Door relay output
AR : Alarm relay output
T1 : TTL #1 output
T2 : TTL #2 output
BZ : Buzzer output

The output time differs, depending on the time unit.
If the time unit is 0.1 (second), you can specify the value between 0.0 and 9.8 second; if set to 1 (second), you can 
specify between 0 and 98 seconds.
For the time unit, refer to the ‘Time Unit Setup’ under the advanced setup. (see page 54)

If you enter 99 for the value, the product stays in output mode until you change the setting regardless of the time 
unit.

READER #1 Time Schedule Error Output Setup

Press the 

 SETUP MENU button.

Use the buttons 

 and 

 to move to the RD1 T/S ERROR item and 

press 

.

The operation time for each output is the same as in “READER #1 ID Error 
Output Setup” above.

Time schedule must be confi gured before. (See Page 55 for “Time Schedule Setup”.)

READER #1 Antipassback Error Output Setup

Press the 

 SETUP MENU button.

Use the buttons 

 and 

 to move to the RD1 APB ERROR item and 

press 

.

The operation time for each output is the same as in “READER #1 ID Error 
Output Setup” above.

APB mode must be enabled before. (See Page 55 for “AntiPassBack Mode”.)

•
•

M





•

M



•

M



5.RD1 ID ERROR

D R   A R   T 1   T 2   B Z
0 0   0 3   0 0   0 0   0 0

5.RD1 ID ERROR

D R   A R   T 1   T 2   B Z

_ 0   0 3   0 0   0 0   0 0

7.RD1 APB ERROR

D R   A R   T 1   T 2   B Z
0 0   0 3   0 0   0 0   0 0

6.RD1 T/S ERROR

D R   A R   T 1   T 2   B Z
0 0   0 3   0 0   0 0   0 0