Canon ir2016, ir2020 マニュアル

2-1

The finisher consists of four blocks: a stack tray, stapler, intermediate process tray, and feeder blocks.

The following illustration shows locations of these four blocks and the finisher controller PCB.

F-2-1

The operation sequence of the finisher is controlled by the finisher controller PCB.

The finisher controller PCB incorporates a 16-bit CPU to perform sequence control (and serial communication with the host machine).

The CPU on the finisher controller PCB incorporates a ROM that stores an operation sequence program.

The finisher controller PCB drives motors in response to the commands sent from the host machine via a serial communication line.

The finisher controller PCB also sends information about various sensors and switches to the host machine via the serial communication line.

F-2-2

1) The offset roller [1] rises.

2) Paper is fed only with the feed roller [2]. (The offset roller and feed roller are driven together.)

Finisher controller

PCB

Motor

Sensor

Solenoid

Switch

Clutch*1

*1: Only when option tray is installed

Motor driver

CPU

Host machine

(DC controller PCB

with CPU)

Motor*1

Sensor*1

Option tray PCB*1