Canon ir2016, ir2020 マニュアル
Chapter 3
3-11
F-3-65
3.5.1.6 Removing the Drive Unit
0010-6567
1) Remove the three TP screws (M4 x 12) [1], one RS tightening screw (M3
x 8) [2], and the drive unit [3].
F-3-66
3.5.1.7 Removing the Process Tray Unit
0010-6568
1) Remove the stepped screw [1] (rear side) and RS tightening screw [2]
(front side), and then remove the stay [3] and process tray [4] (right side).
F-3-67
2) Remove the stepped screw [5] (front side) and RS tightening screw [6]
(rear side), and then remove the process tray [7] (left side).
F-3-68
3.5.1.8 Removing the Stapler
0010-6570
1) Disconnect the two connectors [1] from the stapler. Remove the RS tight-
ening screw [2], and then remove the stapler [3].
F-3-69
3.5.1.9 Removing the Stack Tray Paper Surface Sensor
0010-6571
1) Disconnect the connector [1], and then remove the stack tray paper surface
sensor [2].
F-3-70
3.5.2 Stack Tray Lower Limit Sensor
3.5.2.1 Removing the Rear Cover
0011-1361
1) Open the front cover of the host machine.
2) Remove the four RS tightening screws (M3x8) [1], and then detach the
rear cover [2].
[5]
[2]
[6]
[4]
[3] [1]
[1]
[2]
[3]
[2]
[4]
[3]
[1]
[7]
[5]
[6]
[1]
[3]
[2]
[1]
[2]