Apple emac ati usb2 2005 サービスマニュアル

eMac ATI Graphics/ USB 2.0/2005 Take Apart - 103

 Display/Analog Assembly

Before you begin, do the following:

• Place the computer face down on an ESD mat

• Remove the user access door

• Remove the feet

• Remove the rear housing 

• Discharge the CRT.

• Remove the fan

• Remove the Faraday plate

• Remove the digital assembly

• Remove the AirPort Extreme Card

• Remove the front bezel

• Remove the antenna.

If you remove everything listed in the steps above, you are left with the display/analog 

module. There is nothing more to remove from this module. 

Note: The display/analog assembly contains a non-switching power supply which is preset 

at a 220V configuration.The voltage selection needs to be manually set by the way of a 

voltage jumper. This means if you are operating the computer in a 110V environment, you 

will have to install the voltage jumper. Refer to the Troubleshooting chapter, “Digital/

Analog” 

Replacement Note: If you are returning a defective display/analog module, it is imperative 

that proper packaging guidelines be followed. The packing procedure is included with the 

replacement assembly. Incorrect packaging can result in damaged eMac (ATI Graphics) 

displays. Please read and follow the directions enclosed in the shipping box of the new 

display prior to packaging the defective module.

Failure to package the defective module according to the instructions may result in liability 

for the cost of the damaged display.