abit wlp-01 ユーザーズマニュアル
2. Hardware Installation
2.1 System Requirements
Before installing WLP-01, make sure your system meets the following requirements.
• A motherboard with PCI Express Slot
• Minimum 64MB system memory
• Operating system
Station mode: Windows XP/Server 2003, Windows XP/Server 2003 x64
AP/wireless bridge mode: Windows XP/Server 2003
AP/wireless bridge mode: Windows XP/Server 2003
• An optical drive for utilities and driver installation
2.2 Hardware Installation
The WLP-01 package comes together with an omni-directional portable antenna to extend its
maximum operating range.
maximum operating range.
1.
Power off your system before installing
the WLP-01 card.
the WLP-01 card.
(This picture is for reference only, and may have
size, shape, or parts differences in the antenna or
WLAN card itself.)
size, shape, or parts differences in the antenna or
WLAN card itself.)
2.
Locate one available PCI-E X1 slot on
your motherboard. (Due to each
motherboard’s different designing,
it is recommended to install the
WLP-01 card on PCI-E X1 slot, so as
to avoid degrading the speed of the
PCI-E X16 card.)
your motherboard. (Due to each
motherboard’s different designing,
it is recommended to install the
WLP-01 card on PCI-E X1 slot, so as
to avoid degrading the speed of the
PCI-E X16 card.)
3. Plug
the
WLP-01 card with its
connector-side vertically down into the
slot. (Avoid touching the connector
(golden fingers) when holding the
WLP-01 card.)
slot. (Avoid touching the connector
(golden fingers) when holding the
WLP-01 card.)
4. Secure
the
WLP-01 card by its bracket
onto the chassis’s rear I/O panel.
5.
Connect the cable-end from the external antenna to the antenna port on WLP-01 card.
6.
Place the antenna at an elevated spot. A wide and open position will help to increase the
operating range.
operating range.
WLP-01
7