Alcatel-Lucent omniaccess 6000 ユーザーズマニュアル

Part 031639-00

May 2005

Module Indicator LEDs

This LED is green when the line card is properly installed and the system is 
powered up.

During operation, the Status LED provides the following information:

Access Point Status LEDs

Each LED represents the status of APs connected to a specific port on the 
switch. During operation, the LEDs provide the following information:

The LED states in 

 are listed in order of precedence (highest to 

lowest). If more than one AP is connected to the port, the state with the 
highest precedence is displayed.

7-3 Line Card Status LED

Off

The line card is powered off or initializing.

Green

The line card is operating properly.

Amber

The line card is being initialized.

Red

The line card has failed.

7-4 Line Card AP Status LED

Red (solid)

An AP on this port has failed (highest precedence).

Red (flashing) An air monitor on this port has detected an unsecured AP. 

The AP is attached to your network but is not listed in the 
switch security policies. If security policies are enabled, 
clients are not granted access to your network through the 
unsecured AP.

Green 
(flashing)

An air monitor on this port has detected interference. The 
interfering device (AP or other radio source) has been 
detected by your valid APs, but has no wired presence on 
your network.

Amber (solid)

Load balancing is enabled on this port or an AP has reached 
the maximum number of clients it is configured to support.

Green (solid)

All detected APs on this port are operating as expected.

Off

No AP is detected on the port (lowest precedence)