Alcatel-Lucent ap70 ユーザーズマニュアル
Provisioning Access Points
13
Chapter 2
12 When finished provisioning APs, click Disable to disable AP Provisioning.
N
OTE
—
Disable AP Provisioning after all the required APs are provisioned. Ports that are enabled for
provisioning do not handle traffic. Therefore plugging an already provisioned AP into a port still set to
provisioning mode will prevent that AP from functioning.
provisioning mode will prevent that AP from functioning.
Now the AP is configured with the Parameters given
13 Reboot the AP so the AP will come up with the new configured
parameters.
Use the Reprovisioning tab for APs which are already deployed but need to be
reconfigured. See the AOS-W User Guide for information on reprovisioning.
reconfigured. See the AOS-W User Guide for information on reprovisioning.
Manual Provisioning
Requirements
z
A console terminal (or workstation with terminal emulation software) with
an available serial communications port using a DB-9 male connector.
an available serial communications port using a DB-9 male connector.
z
An Alcatel serial breakout adapter kit, Part Number OAW-AP-SPOE, (not
included). (See
included). (See
.)
z
Access to the OmniAccess OAW-AP70 FE port through one of the follow-
ing:
ing:
z
Direct contact with the AP, or
z
If the AP is already deployed, you must have access to the end of the FE
cable that leads directly to the AP with no intervening hubs, routers, or
other networking equipment.
cable that leads directly to the AP with no intervening hubs, routers, or
other networking equipment.
The cable must be an 8-conductor, Category 5 UTP, straight-through FE cable
with RJ-45 connectors.
with RJ-45 connectors.
z
A power source for the OmniAccess OAW-AP70. Use one of the following:
z
An optional AC power adapter (not included) and an AC power outlet
rated at 100~240 V, 50~60 Hz, or
rated at 100~240 V, 50~60 Hz, or
z
The OmniAccess OAW-AP70 FE port connected to an Alcatel 800,
2400, or 6000 Wireless LAN switch that supports IEEE 802.3af Power
Over Ethernet (POE) via a 4- or 8-conductor, Category 5 UTP,
straight-through FE cable.
2400, or 6000 Wireless LAN switch that supports IEEE 802.3af Power
Over Ethernet (POE) via a 4- or 8-conductor, Category 5 UTP,
straight-through FE cable.
1
N
OTE
—Only IEEE 802.3af Power Over Ethernet is supported for manual provisioning.
“Inline” or “midspan” POE devices require Alcatel serial breakout adapter, Part
Number OAW-AP-SPOE-M.
Number OAW-AP-SPOE-M.