Alcatel-Lucent ap70 사용자 설명서

Chapter 2

12 When finished provisioning APs, click Disable to disable AP Provisioning. 

Disable AP Provisioning after all the required APs are provisioned. Ports that are enabled for 

provisioning do not handle traffic. Therefore plugging an already provisioned AP into a port still set to 
provisioning mode will prevent that AP from functioning.

Now the AP is configured with the Parameters given

13 Reboot the AP so the AP will come up with the new configured 

parameters.

Use the Reprovisioning tab for APs which are already deployed but need to be 
reconfigured. See the AOS-W User Guide for information on reprovisioning.

z

A console terminal (or workstation with terminal emulation software) with 
an available serial communications port using a DB-9 male connector.

z

An Alcatel serial breakout adapter kit, Part Number OAW-AP-SPOE, (not 
included). (See 

.)

z

Access to the OmniAccess OAW-AP70 FE port through one of the follow-
ing:

z

Direct contact with the AP, or

z

If the AP is already deployed, you must have access to the end of the FE 
cable that leads directly to the AP with no intervening hubs, routers, or 
other networking equipment.

The cable must be an 8-conductor, Category 5 UTP, straight-through FE cable 
with RJ-45 connectors.

z

A power source for the OmniAccess OAW-AP70. Use one of the following:

z

An optional AC power adapter (not included) and an AC power outlet 
rated at 100~240 V, 50~60 Hz, or

z

The OmniAccess OAW-AP70 FE port connected to an Alcatel 800, 
2400, or 6000 Wireless LAN switch that supports IEEE 802.3af Power 
Over Ethernet (POE) via a 4- or 8-conductor, Category 5 UTP, 
straight-through FE cable.

1

—Only IEEE 802.3af Power Over Ethernet is supported for manual provisioning. 

“Inline” or “midspan” POE devices require Alcatel serial breakout adapter, Part 
Number OAW-AP-SPOE-M.