AMX design xpress home theater v1.3 ユーザーガイド

 

Govern Power - This option enables governing power to the device, which means that 

the System constantly monitors power to the device (for use with power sensors) rather 

than simply toggling power On/Off.

 

Device/Power Feedback - This option enables the display of power status of the device 

on the touch panel. If this option is enabled, use the radio buttons to specify a Power 

Sensing Method, based on the type of power sensor being used with the device (PSS2, 

VSS2 or TVS).

 

Power Sensing Method - Activated by enabling the Govern Power option (described 

above). Use the radio button to select the method of power sensing being used. This 

available power sensors include: PCS2 (Dual Power Current Sensor), VSS2 (Video Sync 

Sensor), and TVS (TV Sensor).

 

IR Timing Parameters - Use the up/down arrows to adjust the time gap between Power 

On and Power Off IR pulses, in 1/10 second increments (default = 50).

DXP-HT v1.3 (or higher) supports MAX-MMS and MAX-IMS media servers. DXP-HT treats 

these devices essentially the same as any other IP-controlled device (such as MP3 players). There 

are just a few points to understand in order to add MAX servers to a DXP-HT project:

 

The MAX-MMS and MAX-IMS servers are IP-control only, and they must be used with 

AMX G4 touch panels (see Supported Touch Panels).

 

Each MAX-AVM A/V Module connected to a MAX-MMS server must each be set to a 

unique zone number (per server).

 

If multiple MAX-MMS or MAX-IMS servers are used in a project, each server must have 

its own unique IP Address.

Refer to the MAX-MMS and MAX-IMS Installation Guides (available online at www.amx.com) 

for details.