ASUS TS500-E5 ユーザーズマニュアル

Chapter 2:  Hardware setup

2-14

The system comes with three 5.25-inch 

drive bays located on the upper front 

part of the chassis. You can use the bay 

converter that comes with the package 

to convert the 5.25-inch bay to 3.5-inch 

bay for 3.5-inch device such as floppy 

disk drives.

You must remove the front panel 

assembly before installing a 

5.25-inch drive.

1.  Unscrew and remove the metal 

cover of the bay where you want to 

install the 5.25-inch drive, and take 

off the plastic cover on the front 

bezel at the same position.

2.  Insert the drive into the bay and 

slide the bay lock to the right until 

it clicks in place. Screw to double 

secure the drive.

Ensure to unplug the power cable before installing or removing any system 

components. Failure to do so may cause damage to the motherboard and other 

system components!

3.  Connect the IDE cable to the IDE 

connector on the back of the drive.

4.  Connect a 4-pin plug from the 

power supply to the power 

connector on the back of the drive.