Archos 704 tv ユーザーズマニュアル

V1.1

Pre-record

This is a safety margin added to the beginning of a scheduled recording which was set via the My Yahoo!® TV 

scheduler of your personal Yahoo!® calendar. It affects ONLY these recordings. This is just in case the clocks 

between your ARCHOS device and the broadcast station are different or if the broadcast station starts earlier 

than expected.

Post-record

This is a safety margin added to the end of a scheduled recording which was set via the My Yahoo!® TV sched-

uler of your personal calendar. It affects ONLY these recordings. This is just in case the clocks between your 

ARCHOS device and the broadcast station are different or if the broadcast station runs overtime.

8.5  The Infrared eMITTer

Infrared eMITTer

The DVR Station has a high-powered infrared LED at the front. It 

allows your ARCHOS device to communicate with your tuner (VCR, 

cable or satellite box), so that it can turn it on and off, and change 

channels on it.
This is a one time step to set your ARCHOS device to send the cor-

rect infrared codes to control your tuner. If you do not plan on mak-

ing scheduled recordings, then you do not need to set the infrared 

emitter code. 
Before beginning this procedure of setting the emitter code, your 

device must be connected to the DVR Station, which must be pow-

ered with the charger/adapter.

•

•

•

The infrared control works through the reflec-

tion of the infrared signal within a room. 
In order to improve the reception of this infra-

red signal on your tuner (VCR, cable or satellite 

box), you could rearrange the position of the 

DVR Station and/or the tuner such that there 

are more reflective surfaces (furniture, a wall, 

etc. - see diagram). 
Good communication between the DVR Station 

and your tuner also depends on the sensitivity 

of your tuner’s IR receiver.

•

•

•

From the Home Screen, tap on 

 to access the Setup Screen. Tap on the 

 icon to highlight it and tap 

on it again to display the 

 Settings screen.