Archos 704 tv ユーザーズマニュアル

V1.1

Test channel select

When you tap on the 

 button, the ARCHOS device will send a signal through the DVR 

Station’s infrared emitter and change the channel on your tuner (VCR, cable box, or satellite receiver). 
If the Number of digits parameter is set to three, it will try to select channel 123. If that parameter is set to 2, 

it will send the code for channel 12. If your tuner does not change channels when you tap on this test button, 

try the next code for your device: see Tune device 

(multiple codes available).

Key: -/--

Set this to 

 if normally, you have to press this same key on your device’s remote control in order to select a 

channel.

Number of digits

Set the number of digits that your device can recognize for a channel. Example: Set to 3 if you need to choose 

a channel greater than channel 99.

Key: Enter

Set this to 

 if normally, you have to press the 

 button on your device’s remote control after you enter 

the channel number. Example: If you normally press 1, 3, 

 for channel 13, then you would need to set this 

parameter to 

.

Key Delay

Change the delay between the emission of each digit of a channel. You may need to adjust this if the ARCHOS 

device seems to send only half the digits of a channel or more digits of a channel. Example: Adjust the key 

delay and retest channel select if it sends channel 2 instead of 12 or sends 112 instead of 12.

8.6  reCOrdIng audIO (exTernal sOurCe)

You can record audio from an external line-level analog source if you use the optional DVR Station 

or DVR Travel Adapter.
In the Home Screen, tap on the 

 icon to highlight it, then tap again on it to display 

the pre-recording screen.

(see: Using the Browser).
The icon 

You can access the 

 Settings screen 

via the 

 menu item.

This screen allows you to adjust audio input set-

tings for your recordings.
Tap on the  /  buttons to select a different 

setting for a parameter.

•

•

•