avolites pearl exper ttitan ユーザーズマニュアル

8. Cue Lists  - Page 97

 

 

 

 

PearlExpertTitan_Man_v3.doc  29/03/2010 13:28:00 

• 

[Link After Previous Cue]: The cue fires when the previous cue 

has finished its delay in and fade in times. A Link Offset can be 

set to add a delay between the previous cue finishing and this 

cue firing. The offset can be given as a time in seconds, or as a 

percentage of the fade time of the previous cue. 

• 

[Link With Previous Cue]: The cue fires at the same time as the 

previous cue fires. A Link Offset can be set to add a delay 

between the previous cue firing and this cue firing, set either in 

seconds or as a percentage of the fade time of the previous 

cue. 

 

These options allow you to create complex self timed sequences by 

building up simple steps. For example if you wanted the following 

effect: 

• 

Go is pressed, Fixture one starts fading up over 20s 

• 

After 10s Fixture two fades up over 15s 

• 

Both lights stay on for 5s 

• 

Both lights go off in 3s 

You could program 

• 

Cue 1 - Fixture 1 @ 100%, Fade In 20s, Link Wait For Go 

• 

Cue 2 - Fixture 2 @ 100%, Fade In 15s, Link With Previous, 

Link Offset 10s 

• 

Cue 3 - Fixture 1 AND 2 @ 0%, Fade Out 3s, Link After 

Previous, Link Offset 5s 

Note:  To obtain the effect which was called “cue overlap” in previous 

versions of software, use [Link With Previous Cue] and set a 

percentage Link Offset time. Link Offset of 100% is equivalent 

to Cue Overlap of 0% and vice versa.