avolites pearl exper ttitan ユーザーズマニュアル

8. Cue Lists  - Page 99

 

 

 

 

PearlExpertTitan_Man_v3.doc  29/03/2010 13:28:00 

If you press a fixture button twice, it will show X and be 

excluded from the sequence. 

Press Exit to finish setting the fixture order. 

 

The Pearl can run a cue list automatically to a timecode. This is very 

useful for complex performances which must be exactly the same 

time after time, or for unattended operation. Each step in the cue list 

is assigned a time at which it will run. 
The timecode can be read from 

the system clock, from an 

internal timecode source, from 

MIDI or from Winamp. Internal 

timecode is useful for 

programming a sequence which 

will later be triggered by an 

external timecode source. MIDI 

timecode is only available if you 

have a U-DMX board connected. 

To play back a timecoded cue list, press [Connected Cue Lists] and 

select the cue list which is to be played. Then press [Timer …] to 

enable the timecode input. 
When you start the timecode source (or press [Play] if using internal 

timecode), each cue will fire as the timecode matches its 

programmed time. 
You can edit the timecode for each cue by using Wheel A to select the 

cue, then press Enter and type the new timecode for the cue. 
While editing a time you can also use Wheel B to select multiple cues, 

and use the softkey options to enter a value to change the time of all 

the cues (offset, add a fixed time or subtract a fixed time). 
 

Advanced cue list options are set from the Playback Options menu. 

You can enter the playback options menu by doing the following