HP pavilion lc3700n ユーザーズマニュアル

Press the up arrow and down arrow buttons on the 
remote control to highlight i.LINK Setup, and 
then press Select.

Press the up arrow and down arrow buttons on the 
remote control to highlight Standby Mode, and 
then press Select.

Press the left arrow and right arrow buttons on the 
remote control to select Active or Inactive, and 
then press Select.

Active: Power continues to pass through the 
i.LINK circuit so data can be relayed. 

Inactive: Power consumption is minimized 
during standby mode. Data cannot be relayed at 
this setting.

Press the Menu button to view the display. 

■

When the main power of the TV is in standby 
mode (Power indicator lights off), i.LINK control 
commands cannot be received from an i.LINK 
device. This does not change if the Standby Mode 
is set to Active. To control the TV from an i.LINK 
device, turn the TV power on (Power indicator 
lights up in blue). 

■

Data cannot be relayed between i.LINK devices 
when all of the following conditions are met: 
1) More than one i.LINK device is connected to 
the TV with i.LINK cables, 2) Standby Mode is set 
to Inactive, and 3) The power of the TV is in 
standby mode (Power indicator lights off). When 
the TV is connected between two i.LINK devices in 
series, select Active in Standby Mode or connect 
the TV at an end of the series as shown in the 
diagram.

To control an i.LINK device from the TV, you must first 
choose the i.LINK device to be controlled. One i.LINK 
device can be chosen from up to 16 i.LINK connected 
decks. All i.LINK devices connected with i.LINK cables 
should automatically appear in the selection screen.

Press the i.LINK button on the remote control to 
display the i.LINK control panel.

■

If no i.LINK device is detected, the message 
No i.LINK model is available appears. 

■

If no i.LINK device is selected, the selection 
screen appears. Go to step 3. 

Press the arrow buttons on the remote control to 
highlight Model, and press Select to view the 
Selection screen.

Press the up and down arrow buttons on the 
remote control to select a device, and then press 
Select. The control panel for the i.LINK device 
appears.

■

Incompatible devices with this TV do not appear 
in the selection screen.

■

The manufacturer’s name and model name of 
some devices may not display correctly. Follow the 
steps in “Deleting registered i.LINK devices” on 
page 39, and cancel all i.LINK devices you have 
registered before reconnecting the i.LINK cable.

■

Grayed-out devices are not recognized by the TV 
and cannot be selected. The device may not be 
connected properly.

By disabling the TV’s operation of an i.LINK device, the 
device can be operated from another i.LINK device.

Model

Input

PWR

STOP

STOP

05

00:01:32

Type

i.LINK

1/1 [Thu] 1:33AM

Cancel Connection

Manufacturer

Which model do you use?

Model