HP ProLiant ML330 G6 ユーザーズマニュアル

 

Operations 21 

To remove the component: 

1. 

Power down the server (on page 

2. 

Using the key provided with the server, unlock the bezel. 

3. 

Remove the bezel, as needed. 

 

 

Extend the server from the rack 

  

 

NOTE:

  If the optional cable management arm option is installed, you can extend the server 

without powering down the server or disconnecting peripheral cables and power cords. These 

steps are only necessary with the standard cable management solution. 

  

1. 

Power down the server (on page 

2. 

Disconnect all peripheral cables and power cords from the server rear panel. 

3. 

Extend the tray. 

  

 

WARNING:

  To reduce the risk of personal injury or equipment damage, be sure that the rack 

is adequately stabilized before extending a component from the rack. 

  

  

 

WARNING:

  To reduce the risk of personal injury, be careful when pressing the server rail-

release latches and sliding the server into the rack. The sliding rails could pinch your fingers. 

  

4. 

After performing the installation or maintenance procedure, slide the server back into the rack: 

a. 

Press the server rail-release latches and slide the server fully into rack. 

b. 

Secure the server by tightening the thumbscrews. 

5. 

Reconnect the peripheral cables and power cords. 

 

Remove the access panel 

1. 

Power down the server (on page 

2. 

Do one of the following: