Canon imageclass mf4150 ユーザーガイド
1
2
3
4
5
6
Back
5-12
Cannot receive a document manually.
Q
Is the machine set to receive manually?
A
For the machine to receive faxes manually, the
receive mode must be set to <MANUAL>. (See
“Setting the Receive Mode,” on p. 1-8.)
receive mode must be set to <MANUAL>. (See
“Setting the Receive Mode,” on p. 1-8.)
Q
Have you disconnected the call by pressing
[Start] or dialing the remote reception ID after
hanging up?
[Start] or dialing the remote reception ID after
hanging up?
A
Always press [Start] or dial the remote reception ID
before hanging up. Otherwise you will disconnect
the call.
before hanging up. Otherwise you will disconnect
the call.
Print quality is poor.
Q
Is the toner low or unevenly distributed?
A
Redistribute the toner inside the toner cartridge. If
the problem persists, replace the toner cartridge.
(See Chapter 10, “Maintenance,” in the Basic
Guide.)
the problem persists, replace the toner cartridge.
(See Chapter 10, “Maintenance,” in the Basic
Guide.)
Q
Is the correct type of paper loaded in the
machine?
machine?
A
Make sure you load paper that meets the
requirements for use. (See Chapter 3, “Print
Media,” in the Basic Guide.)
requirements for use. (See Chapter 3, “Print
Media,” in the Basic Guide.)
Q
Is the sender’s machine functioning properly?
A
Ask the sender to check that the scanning
components of the machine are clean.
components of the machine are clean.
Q
Is the machine in the toner saver mode?
A
Set <TONER SAVER MODE> to <OFF> in
<COMMON SETTINGS>. (See Chapter 12,
“Machine Settings,” in the Basic Guide.)
<COMMON SETTINGS>. (See Chapter 12,
“Machine Settings,” in the Basic Guide.)