Samsung dc68-02040a-01 ユーザーズマニュアル

- 10 -

■

■

☞ IN CASE OF PUMP-DRAINED WASHER

☞ IN CASE OF GENERAL WASHER

•

The handle of joint ring is pressed to pull out the 
drain hose. Change the direction of the drain 
hose and follow the above guideline again.

Tilt the washer a little and lift up the panel until it clicks, finally fix the panel 
with screw to the base as shown in the figure.

1.    Insert the sound absorbing panel to the assembling 

hole on back side to the end

2.    If you have difficulty inserting the panel lift up the washer 

a little and insert it.

Take out the cap-hose and 
connect the outlet-hose.

Be sure to join tightly the drain hose into 
the drain-outlet on the back of the 
machine.

Be sure to join tightly the drain 
hose into the drain-outlet on 
the side of the machine.

Install the drain hose in the position of 
about 90~100cm above the ground.

Rear-side

90~100cm

1. After pressing the joint ring, insert to the drain 

hose.

2. After directing the drain hose to a drain, join to 

the drain-outlet of the washing machine.

3. Be sure to join them tightly by pressing the joint 

ring and pushing it into the drain-outlet.

•

The length of drain hose is adjustable so that 
you can extend the length appropriately.

1. Don t exceed more than 3m when the 

drain hose is used by connecting whth 
other hoses.

2. Be careful to drain water out at the end of 

the drain hose.

3. The doorsill shoudn t be more than 

5cm.

4. Don t install the drain hose underneath 

the wash machine.

drain-outlet

Less than 3m

Less than 3m

Less 
than 5cm