Samsung dc68-02040a-01 ユーザーズマニュアル

ページ / 14
- 11 -
HOW TO ADD THE FABRIC SOFTENER
HOW TO PUT THE DETERGENT IN
1. Open the detergent box by pulling in the direction of the arrow as shown in 
the figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may not brim 
over the box.
CAUTION : If softener is stored over the above base line, it may flow down at 
any time.
WATER SUPPLY CONNECTOR FILTER
CLEANING THE FILTER 
 
Clean the filter net often to keep the washer clean.
HOW TO CLEAN THE PUMP FILTER
When a proper amount (one time does) of fabric softener is 
stored in the softener inlet, it is automatically put in at the last 
rinsing cycle.
Do not use detergent, bleach or starch into the Softener Inlet.
Using too much softener (more than 40CC) may 
produce unsatisfactory results.
Do not open the lid during the Spin Dry cycle. If 
added too early, its effectiveness will decrease.
Do not leave the softener into the Softener. 
Dispenser for a long time. Because softner 
became stiff.
1. Pull out the filter and 
wash well.
2. Pull in the filter and 
connect the hose to the 
inlet water valve tightly.
3. Check if there is a 
leakage. 
Note to tighten up 
the connector.
Detergent Device
Put the 
detergent in proportion 
to Water level
Softener
baseline
Softener Device
••••••••••
••••••••
••••••••••••••••••••
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
inlet water 
valve
1. Push the upper part of the Magic 
filter and pull in.
1. Push up and pull out the filter net.
2. Open the cover as shown in the 
figure.
2. Remove the collected lint from the 
filter net.
3. Clean the Magic filter.
3. Clean the filter net.
4. Close the cover and insert the 
lower part of the filter in the 
basket first and then push the 
filter with  click  sound.
4. Pull down the filter net.
1. Place a rag under the washer filter not to 
wet the floor.
2. Rotate the filter counterclockwise and pull 
out the filter.
3. Remove dirts and rotate the filter clockwise 
until it locks in position.