Juniper CBL-M40-PWR-AU ユーザーズマニュアル
Provide Power to the Router
M40 Internet Router Hardware Guide
126
3.
Turn on the power to the management device that is connected to the Routing Engine
through the craft interface port labeled
through the craft interface port labeled
CONSOLE
,
AUXILIARY
, or
MANAGEMENT ETHERNET
.
For more information on connecting management devices, see “Connect the Router to
Management and Alarm Devices” on page 119.
Management and Alarm Devices” on page 119.
4.
Press the power switch on one power supply to the
ON
(
|
) position. Verify that the green
LED labeled
OK
on the power supply faceplate eventually lights steadily.
5.
Press the power switch on other power supply to the
ON
(
|
) position and confirm that
the
OK
LED lights as described in Step 4. If the LED is not lit after 60 seconds, repeat the
power supply and cable installation procedures described in “Reinstall the Power
Supplies” on page 118, and “Connect Power to an AC-Powered Router” on page 123 or
“Connect Power to a DC-Powered Router” on page 123.
Supplies” on page 118, and “Connect Power to an AC-Powered Router” on page 123 or
“Connect Power to a DC-Powered Router” on page 123.
6.
On the management device, monitor the startup process to verify that the system has
booted properly.
booted properly.
After a power supply is turned on, it can take up to 60
seconds for status indicators—such as LEDs on the power
supply,
seconds for status indicators—such as LEDs on the power
supply,
show chassis
commands, and messages on the
craft interface LCD—to indicate that the power supply is
functioning normally. Ignore error indicators that appear
during the first 60 seconds.
functioning normally. Ignore error indicators that appear
during the first 60 seconds.
The Routing Engine boots as the power supply completes
its startup sequence. If the Routing Engine finishes booting
and you need to power down the router again, first issue
the CLI
its startup sequence. If the Routing Engine finishes booting
and you need to power down the router again, first issue
the CLI
request system halt
command. For complete
instructions, see “Disconnect AC Power from the Router”
on page 140 or “Disconnect DC Power from the Router”
on page 147.
on page 140 or “Disconnect DC Power from the Router”
on page 147.
If after powering on the power supply you must power it
off, wait at least 60 seconds. After powering off a power
supply, wait 60 seconds before turning it back on.
off, wait at least 60 seconds. After powering off a power
supply, wait 60 seconds before turning it back on.