Juniper CBL-M40-PWR-AU ユーザーズマニュアル
Replace the SCB
M40 Internet Router Hardware Guide
170
To replace the SCB, perform the following procedures:
Remove the SCB
The SCB is located at the center of the card cage, at the front of the chassis (see Figure 1). It
weighs approximately 1 lb (0.5 kg).
weighs approximately 1 lb (0.5 kg).
To remove the SCB, follow this procedure (see Figure 79):
1.
Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the SCB.
2.
Attach an ESD strap to your bare wrist and connect the strap to one of the ESD points on
the chassis.
the chassis.
3.
Unscrew the thumbscrew at each end of the SCB, using a Phillips screwdriver if
necessary.
necessary.
4.
Pull the ends of the extractor clips (which are adjacent to the thumbscrews) outward,
toward the ends of the SCB.
toward the ends of the SCB.
5.
Grasp both sides of the SCB and slide it about halfway out of the chassis.
6.
Place one hand under the SCB to support it, slide it completely out of the chassis, and
place it on the antistatic mat or in the electrostatic bag prepared in Step 1.
place it on the antistatic mat or in the electrostatic bag prepared in Step 1.
Figure 79: Remove the SCB
1052
Thumbscrew
Extractor clip