Juniper CBL-M40-PWR-AU ユーザーズマニュアル
Replace the Routing Engine
M40 Internet Router Hardware Guide
176
3.
Align the rear of the unit with the slide guides in the chassis.
4.
Slide the unit completely into the chassis.
5.
Using a Phillips screwdriver, tighten the screws along the left and right edges of the
Routing Engine housing (six in all).
Routing Engine housing (six in all).
Figure 82: Install the Routing Engine Housing
Replace the Routing Engine
The Routing Engine is hot-pluggable, as described in “Field-Replaceable Units (FRUs)” on
page 4. When it fails or is removed from the chassis, forwarding halts until it is replaced and
functioning again.
page 4. When it fails or is removed from the chassis, forwarding halts until it is replaced and
functioning again.
To replace the Routing Engine, perform the following procedures:
1055
The appearance and position of electronic components or
the PC card slot on your Routing Engine might differ from
the figures in this section. These differences do not affect
Routing Engine installation and removal or functionality.
the PC card slot on your Routing Engine might differ from
the figures in this section. These differences do not affect
Routing Engine installation and removal or functionality.