Juniper CBL-M40-PWR-AU ユーザーズマニュアル
Replace the Routing Engine
M40 Internet Router Hardware Guide
178
Figure 83: Remove the Routing Engine
Install the Routing Engine
To install the Routing Engine in the Routing Engine housing, follow this procedure (see
Figure 82):
Figure 82):
1.
Attach an ESD strap to your bare wrist and connect the strap to one of the ESD points on
the chassis.
the chassis.
2.
Verify that the extractor clip at each end of the Routing Engine is flipped toward the
outer edge of the unit. If necessary, use your thumbs to push and hold the red tab on
each extractor clip toward the outer edge, then push the ends of the extractor clips
outward.
outer edge of the unit. If necessary, use your thumbs to push and hold the red tab on
each extractor clip toward the outer edge, then push the ends of the extractor clips
outward.
3.
Place one hand under the Routing Engine to support it and grasp one of the extractor
clips on the faceplate with the other hand.
clips on the faceplate with the other hand.
4.
Align the rear of the Routing Engine with the guide rails in the Routing Engine housing
and slide it in completely. See Figure 84.
and slide it in completely. See Figure 84.
PC CARD
RST
IDE
JUNOS PC CARD
LABEL THIS
W
AY
1004
Be careful to align the Routing Engine correctly with the
guide rails and push it in evenly. Damage can result if it
gets lodged because of uneven movement.
guide rails and push it in evenly. Damage can result if it
gets lodged because of uneven movement.