Juniper CBL-M40-PWR-AU ユーザーズマニュアル

Maintain and Replace Routing Engine Components

5.

Press the extractor clip at each end of the Routing Engine inward to seat the unit firmly 
in the chassis.

6.

If screws are installed in the extractor clips, use a Phillips screwdriver to tighten them.

7.

Return the Routing Engine housing to the chassis. For instructions, see “Install the 
Routing Engine Housing” on page 175.

8.

After the Routing Engine restarts, check the Routing Engine LEDs on the craft interface 
to verify that the green LED labeled 

OK

 is lit (see Figure 7). 

You can also verify correct Routing Engine functioning by issuing the 

show chassis routing-engine

 command described in “Maintain the Routing Engine” on 

Figure 84:  Install the Routing Engine

1030

PC CARD

RST

IDE

JUNOS PC CARD

LABEL THIS 

W

AY