Juniper CBL-M40-PWR-AU ユーザーズマニュアル
Hardware Component Overview
Power Supplies
21
For information about the cables required for each type of power supply, see “Power System
Requirements and Specifications” on page 44.
Requirements and Specifications” on page 44.
See the following sections for further information about the power supplies:
AC Power Supply
An AC-powered router has two load-sharing AC power supplies, located at the bottom rear of
the chassis, as shown in Figure 2. Figure 8 shows the power supply and Table 8 lists electrical
specifications. For information about the LEDs on the power supply, see “Power Supply
LEDs” on page 22.
the chassis, as shown in Figure 2. Figure 8 shows the power supply and Table 8 lists electrical
specifications. For information about the LEDs on the power supply, see “Power Supply
LEDs” on page 22.
Figure 8: AC Power Supply
Table 8: AC Power Supply Electrical Specifications
Captive
screw
screw
Power switch
Status LEDs
Handle
Extractor/inserter
Grounding points
Appliance inlet
Safety interlock lever
Description
Specification
Maximum power outpu
t
1500 W
Input voltage
180–264 VAC operating range
Input line frequency
50–60 Hz, autoranging
Input current rating
8A @ 208V
Output voltage
+3.3V, +5V, +2.5V, +12V, +24V